Maintenance And Diagnosis Of Failures; Maintenance; Failure Diagnosis - Erreka TOPO Manual Del Instalador

MAINTENANCE AND DIAGNOSIS OF FAILURES

1

MAINTENANCE


Before carrying out
operation, disconnect the device from the
power supply.
1 Frequently check installation in order to discover any
imbalance or signs of deterioration or wear. Do not
use the device if any repair or adjustment is
necessary.
2 Clean and lubricate the articulations and rails of the
gate, so as not to increase the effort of the operator.
3 Check that the key and safety devices (photocells or
strips), as well as their installation, have not suffered
any damage from the weather or external agents..
4 Check that drainage is completed correctly, without
any water becoming accumulated inside the base
box. Where appropriate, unblock the drainage
ducts.
2

FAILURE DIAGNOSIS

Problem
The operator does not make any
movement when the opening or
closing key devices are activated
When using the opening or closing
key devices, the operator
activated but the gate does not
move
The gate moves in an irregular
manner
The gate cannot completely close
(or open)
any maintenance
Cause
Absence of system power voltage
Defective electrical installation
Control board or key commands
defective
Gate obstructed or blocked
is
G a t e p a r t i a l l y o b s t r u c t e d o r
blocked
The gate pivot is not on the upright
of the operator pivot
The photocell detects an obstacle
The resistance of the gate has
increased when closing (or when
opening)
The force of the operator during
closing (or opening) is too low
The mechanical stoppers of the
g a t e o r t h e o p e r a t o r a r e
maladjusted
5 Apply grease to the pivot using the greaser (1).
6 Lubricate the articulations (2).
Solution
Re-establish the power supply
voltage
Check that the installation does
not present any short-circuits or
cut-off points
Check these elements, seeing their
respective manuals
Unblock, adjust and lubricate the
gate articulations
Unblock, adjust and lubricate the
gate articulations
Align the pivots (see "Position the
b a s e b o x a n d t h e d u c t s " o n
page 51)
Eliminate the obstacle and try
again
Check the moving parts of the gate
and eliminate the resistance
U s i n g t h e
programme, increase the closing or
opening force
Adjust the stoppers
TOPO underground electromechanical operator
English
c o n t r o l p a n e l
59