Andis RACA-2 Instrucciones De Uso Y Cuidado página 5

USING THE ATTACHMENT COMBS
You can set the blades for a longer cut by using any of the attachment combs made
for your Andis clipper. The combs mount easily; simply slip the cutter blade teeth
into comb and snap the comb down (Figures A & B). To remove, simply snap off.
These attachment combs guide hair into the blades and give you precise control of
hair lengths. The length of trim is indicated on the attachment comb. Use the chart
to find the approximate lengths of cut. Different blade angles in relation to the skin,
thickness and texture of the hair will vary the cutting length.
CLIPPER BLADE ADJUSTMENT
Your Andis adjustable clipper blade set is easy to adjust. From short to longer cuts,
all that is needed is a flick of the adjustment lever with your thumb. In the upright
position, the blades are set for the shortest cuts (Figure C).
USER MAINTENANCE
The internal mechanism of your clipper has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual,
no other maintenance should be performed, except by Andis Company or an
Andis authorized service station.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
Blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign blades need oil. Hold the clipper with
the blades pointing down to prevent oil from getting into the motor. Place a few
drops of Andis Clipper Oil on the front and side of the cutter blades (Figure D). Wipe
excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil for
good lubrication, but are an excellent clipper blade coolant. Always replace broken
or nicked blades to prevent injury. You can clean the excess hair from your blades
by using a small brush or worn out toothbrush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus, while the
clipper is running. Any excess hair and dirt that has accumulated between the blades
should come out. After cleaning, turn your clipper off and dry blades with a soft, dry
cloth and start clipping again.
5