Before You Start; Tools; Water; Gas - ALLIANCE SWD619N Instalación/Operación

Installation

Before You Start

Tools

For most installations, the basic tools you will need
are:
1
7
1 Wrench
2 Screwdrivers
3 Pliers
4 Socket Wrench
5 Teflon Tape
6 Level
7 Duct Tape
Figure 1

Water

Washer needs two standard 3/4 inch (19.1 mm) water
supply faucets with a pressure between 20 and
120 pounds per square inch (138 to 827 kPa). For
more detailed information, refer to section on Water
Supply Requirements.

Gas

Dryer is equipped for Natural Gas with a 3/8 inch
N.P.T. gas supply connection. For more detailed
information, refer to section on Gas Requirements.

Location

Place the unit on a solid floor with an adequate air
supply. For more detailed information, refer to section
on Location Requirements.
16
2 3
4
6
5
D814I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Exhaust

Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
NOTE: For more detailed information, refer to
section on Dryer Exhaust Requirements.
Figure 2

Electrical

WASHER
Refer to serial plate for specific electrical
requirements. For more detailed information,
refer to section on Washer Electrical
Requirements.
ELECTRIC DRYER
Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt,
60 Hertz, 30 Amp, AC single phase electrical
supply. For more detailed information, refer to
section on Electric Dryer Electrical
Requirements.

GAS DRYER

Dryer needs a 120 Volt, 60 Hertz, 15 Amp,
polarized 3-slot effectively grounded receptacle.
For more detailed information, refer to section on
Gas Dryer Electrical Requirements.
NOTE: 208 Volt heating element is available (as
optional equipment at extra cost).
H311I
801539