Location Requirements - ALLIANCE SWD619N Instalación/Operación

Location Requirements

Select a location with a solid, sturdy and level floor.
DO NOT install unit on carpeting, soft tile, pedestal, a
platform or other weakly supported structures.
The unit must not be installed or stored in an area
where it will be exposed to water and/or weather.
All four legs must rest firmly on the floor so the
weight of the unit is evenly distributed. The unit must
not rock and must be level from side-to-side and front-
to-back.
A
Area
A Left Dryer Side
B Right Dryer Side
C Dryer Top
D Dryer Rear
E Exhaust Duct Clearance to Combustible Materials
NOTE: Shaded areas indicate adjacent structure.
801539
B
Dryer and Exhaust Duct Clearances
Description
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
IMPORTANT: Unless completely assembled, DO
NOT slide the unit across the floor. DO NOT slide
the unit more than four feet once the leveling legs
have been extended, as the legs and the base could
become damaged.
The unit needs sufficient clearance and an adequate air
supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown in Figure 34.)
0 in. (0 cm)
1 in. (2.54 cm)
6 in. (15.24 cm)
4 in. (10.2 cm)
2 in. (5.1 cm)
Figure 34
Installation
C
D
E
E
SWD748N
Minimum Clearance
SWD748N
41