Step 3: (Non-Gravity Drain Models Only) Connect Drain Hose To Drain Receptacle - ALLIANCE SWD619N Instalación/Operación

Step 3: (Non-Gravity Drain Models Only)
Connect Drain Hose to Drain Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by removing the shipping tape.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-3/8 inch (3.5 cm) outside
diameter drain hose.
1 Shipping Tape
Figure 6
801539
1
SWD622N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Standpipe Installation
Place the drain hose into the standpipe.
Remove the beaded tie-down strap from accessories
bag and place around standpipe and drain hose and
tighten strap to hold hose to standpipe. This will
prevent the drain hose from dislodging from drain
receptacle during use.
1
24 TO 36 in.
(61 TO 91.44 cm)
RECOMMENDED
HEIGHT
3
2
1 Drain Hose
2 Standpipe – 2 in. (5.08 cm) or 1-1/2 in.
(4 cm)
3 Beaded Tie-Down Strap
Figure 7
Installation
SWD623N
SWD623N
19