Publicidad
Idiomas disponibles
Idiomas disponibles
Proceed as follows:
•
Drill a hole ø 5,25 inches (134 mm) in an outside wall or
through a wooden kickboard. Respect the dimensions and
height of the hole given in figure 3 and 4.
3
in the wooden
kickboard of a French
window or panel
•
Fit the wall flange B1 into the hole.
•
Fit the hose B2 into the wall flange B1 as shown in fig. 4.
When the hose B2 is not connected, the drilled hole can be
•
closed with the flange cap B1.
4
•
When installing the air conditioner, you should leave a door
slightly open little as 1/2" (1 cm) to guarantee correct ven-
tilation and room pressure.
•
Keep the air hoses as short and free of curves as possible to
avoid constrictions.
Note:
As special tools are required for this type of
•
installation, we suggest you have the appliance in-
stalled by specialized personnel.
in the wall:
you are
recommended to insulate the
section of wall using
suitable insulation
max 39 in
max 100 cm
min 14 in
min 35 cm
CONDITIONING WITHOUT INSTALLATION
You can also set-up in a double-hung window:
•
Place the window bracket in the window sill, extend the
bracket fully within the window frame, fix the bracket by
using the pin then lower the window onto the bracket.
(Should the window bracket be too large for the window,
the plastic can be cut with a saw by a qualified profes-
sional.)
•
Fit the air exhaust hose B2 in the relevant housing located
on the rear side of the appliance. (fig. 1).
•
Connect the window outlet B3 to the other end of the ex-
haust hose.
Insert the window outlet B3 of the exhaust hose into the
•
slot of the window bracket (fig. 5).
5
Other set-up methods:
•
Thanks to the locking pins, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see figure 6).
6
6
Publicidad
