Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: Do not make any adjustment of the dial during operation. Holding the main
body with one hand can swing you around, resulting in an injury.
This machine has an electronic controlled circuit built-in, enabling stepless regulation
of the number of strikes. Make the most of this machine by adjusting the dial according
to the working contents; chiseling, demolishing, or the quality of the material to be
chiseling or demolishing.
The scale "1" of the dial is for the minimum speed with 930 strikes per minute, and the
scale "6" is for the maximum speed with 1,650 strikes per minute.
Standard number of strikes
Dial
Number of strikes/min.
6
5
4
3
2
1
HOW TO USE THE DEMOLITION HAMMER
1.
After placing the tip of the tool on concrete surface, switch
ON.
The switch can be turned ON if the trigger is pulled and OFF
when it is released.
If the stopper is pressed while the trigger for the switch is
pulled, even if your finger is released from the trigger, the
switch remains ON - convenient for continuous operation.
To turn the switch OFF, pull the trigger again, and then the
stopper comes off.
2.
By utilizing the empty weight of the machine and by firmly
holding the demolition hammer with both hands, one can
effectively control the subsequent recoil motion.
Proceed at a moderate work-rate, the use of too much force will impair efficiency.
CAUTION: After long time of use, the cylinder case becomes hot.
Therefore, be careful not to burn your hands.
1,650
1,590
1,460
1,320
1,110
930
Dial
Fig. 9 (H60MRV)
Fig. 10
English
13
Publicidad
