Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION CON'T.
4. Connecting the Natural Gas Supply Line (con't.):
During installation to the pipe, make certain that the regulator is rotated to align the rear of the regulator body with the right side wall
of the grill (see Figure 7 ). This will ensure that there is no interference between the regulator and the grill mounting bracket used in
the enclosure.
5.
The grill is now ready to be installed in the enclosure. Take care not to damage the regulator during installation. Two persons
are required to lift the grill and place in the enclosure.
After installing the grill in the enclosure:
1.
Connect the home gas supply line to the inlet side of the natural gas appliance regulator by following the recommended
connection methods noted above. Apply pipe joint compound (not provided) to the inlet piping prior to connecting to the
regulator.
2.
Confirm all grill control knobs are turned to
3.
Turn ON the home gas source.
4.
Proceed to step 5, Leak Testing.
NOTE: It is recommended that a manual shut-off valve be
installed outside the grill enclosure (see Figure 8).
Figure 7
Side View
OFF.
Enclosure
Trim
Flanges
Enclosure
Natural Gas
Regulator
Gas Inlet Pipe
Dedicated Manual
Shut Off Valve
Gas Inlet Pipe
Figure 8
Top View
To Gas System
15
Publicidad
