Publicidad
Idiomas disponibles
Idiomas disponibles
AIR SUPPLY
Whip Hose
Do Not Install
Quick Coupling
Nipple
Here
Leader
Hose
Tools of this class operate on
a wide range of air pres s ures.
We recommend that air pressure
mea s ures 90 PSI at the air inlet
while in use. Low pressure (less
than 90 psig 6.2 bar) re d uc e s the
speed and performance of all air
tools. High pres s ure (over 115 psig
8.0 bar) exceeds the rated capacity
of the tool, which will short e n tool
life through faster wear and could
cause injury.
Always use clean, dry air. Dust,
corrosive fumes, and/or water in
the air line will cause damage to
LUBRICATION
Lubricate the air motor daily with
NAPA air tool oil. If no air line oiler
is used, run 1/2 oz. of oil through
the tool. The oil can be squirted
please revieW all Warning insTrucTions prior To operaTion. save This Man u al for fuTure ref er ence.
please revieW all Warning insTrucTions prior To operaTion. save This Man u al for fuTure ref er ence.
6-231 C
Nipple
Quick Coupler
Oiler
the tool. Drain the air tank daily.
Clean the air inlet filter screen at
least per week.
The air inlet used for con n ect i ng
air supply, has stan d ard 1/4" NPT
American Thread. Line pressure
should be increased to compensate
for unusually long air hoses (over
25 feet). Minimum hose diameter
should be 3/8" I.D. Fittings should
have the same inside dimensions
and should be tightly secured.
into the tool air inlet or into the
hose at the nearest con n ec t ion to
the air supply, then run the tool.
The oil plug is only for adding
Air Supply
Filter
Regulator
Drain Daily
3
S
pecificationS
Max. Free Speed ............... 8,000 RPM
Max Torque....................... 650 ft. lbs.
Working Torque ..........25-400 ft. lbs.
Air Inlet ............................... 1/4" NPT
Min. Hose Size ..................... 3/8" I.D.
Avg. Air Cons. ...................... 5.5 CFM
Recom. Air
Pressure ..................90 PSIG (6.2 BAR)
Weight .................................... 5.8 lbs.
Length ......................................7.125"
Sound Level ..........................103 dBA
Air Inlet
multi-purpose grease after repair
or maintenance of the impact
mechanism. Overfilling will cause a
re d uc t ion in the power of the tool.
Air
Regulator
Knob
Rev. 08/15/13
Publicidad
