Descargar Imprimir esta página

Pioneer DEH-P3590MP Manual De Instrucciones página 35

Publicidad

Idiomas disponibles

Idiomas disponibles

Initial Settings
Adjusting initial settings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1 Function display
Shows the function status.
1
Press SOURCE and hold until the unit
turns off.
2
Press FUNCTION and hold until function
name appears in the display.
3
Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
FM (FM tuning step)A-PI (auto PI seek)
WARN (warning tone)AUX (auxiliary
input)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down FUNCTION until the unit turns off.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
All manuals and user guides at all-guides.com
1
Press FUNCTION repeatedly until FM appears
in the display.
2
step.
Pressing c or d will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1
Press FUNCTION repeatedly until A-PI ap-
pears in the display.
2
Pressing a or b will turn A-PI on or off and
that status will be displayed (e.g., A-PI :ON).
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1
Press FUNCTION repeatedly until WARN ap-
pears in the display.
Press FUNCTION to select FM.
Press c or d to select the FM tuning
Note
Press FUNCTION to select A-PI.
Press a or b to turn A-PI on or off.
Press FUNCTION to select WARN.
Section
10
35
En

Publicidad

loading