Publicidad
Idiomas disponibles
Idiomas disponibles
4 Turn the blade flange hub carefully so that it slides into one
of the tracks in the pivot arm and lands in the correct
position to be screwed fast.
5 Press in the blade spindle into the cutting arm at the same
time as the blade is rotated carefully. When the blade
spindle can no longer be pressed in by hand it should be
tightened using the supplied 18-spanner until it is properly
secured (tightening torque 70-80 Nm).
WARNING! Exercise care when assembling
!
the blade so that it does not risk becoming
loose when cutting. Carelessness can result
in serious personal injury or even death.
Flush cutting
Screw off the outer blade flange and mount the blade on the
blade flange hub.
A=110 mm/4.33 inch, 6xM10
B=89 mm/3.5 inch, 6xM8
C=144 mm/5.7 inch
12 –
English
ASSEMBLY
Fit the blade guard
!
1 Slip in the blade guard guide between the stays on the
blade guard. Place the blade guard guide in the middle.
Lock the plastic heel on the handle to the upper stay on
the blade guard.
2 Make sure that the pivot arm is positioned vertically. Lift
the blade guard over the blade and hang the guard in the
blade guard holder on the saw. Exercise care so that the
runners on the blade guard are positioned in the slots on
the water block.
3 Lock the blade guard by pulling the handle out of the
guard and then down towards the saw unit so that the
latch locks the handle.
WARNING! Never mount or dismount the
blade or blade guard without first switching
off the hydraulic unit and disconnecting the
hydraulic hoses running to the saw unit.
Carelessness can result in serious personal
injury or even death.
Publicidad
