Publicidad
Idiomas disponibles
Idiomas disponibles
7
ATTACH CABLE CONNECTOR
• Thread CABLE CONNECTOR (1) clockwise
onto DRAIN BODY CONNECTION (2) and
hand tighten. Fig. A.
Your new POP-UP DRAIN installation is
now complete. Fig. B.
Note: Tailpeice on pop-up drain is 1-1/4" O.D.
Fig. B.
8
CHECK OPERATION OF POP-UP
• Operate LIFT KNOB (1) to verify that STOPPER (2) opens
and closes.
Note: If STOPPER (2) does not open and close
properly then refer to the "troubleshooting section" of
these instructions.
9
TEST INSTALLED FAUCET
• Remove AERATOR. With handles in OFF position, turn on water supplies and check all connections for leaks.
• Operate both handles to flush water lines thoroughly. Operate LIFT ROD and check DRAIN for leaks. Replace AERATOR.
Fig. A.
1
2
- 3 -
Fig. B.
1-1/4" O.D.
1
2
M965805 1.0 (4/22)
Publicidad
