Publicidad
Idiomas disponibles
Idiomas disponibles
If the ambient temperature differ-
ence occurs even when the hob is
not operating while the automatic
mode is active, the temperature
sensor in the product will detect the
difference and the product may
start operating at Speed 2 or 3 de-
pending on the difference. In this
case, automatic mode will be
turned off when the temperature
difference is equalized.
Do not use automatic mode when
your hob is not working.
If there is another factor that may
increase the heat in the environ-
ment apart from the hob, the dura-
tion of automatic mode might pro-
long.
Air cleaning mode
ü You can use air cleaning mode to elim-
inate the odour in your house during a
long time at low level.
1. Touch the
key.
ð Air cleaning mode is activated. The
light of the
air cleaning mode is active.
2. The air cleaning mode will operate at
Speed 1 for 10 minutes in 1 hour and
will stop for 50 minutes. If you do not
switch off the air cleaning mode, it will
remain in operation for 10 minutes, then
stop for 50 minutes in each hour for 24
hours.
When air cleaning mode is active, it
is automatically cancelled at the
touch of any key except lamp key.
Your hood continues to operate at
the function of the key you touch. It
can be cancelled by touching the
key.
key flashes when the
Timer function
ü You can use the timer function to make
your hood operate for 15 minutes at
the desired speed level and turn it off
automatically at the end of the time.
1. Touch the speed level at which you want
to operate your hood.
2. Activate the timer by touching the
key.
ð The hood operates for 15 minutes at
the speed level you set. If no key is
touched, it turns off automatically at
the end of the period.
If you touch the
ting any speed level, the hood oper-
ates for 15 minutes at Speed 1 level
and turns off at the end of the time.
Cancelling the timer function
1. Touch the
ive.
ð The timer is cancelled and your hood
turns off.
If you touch a different speed level
when the timer is active, the timer
will be cancelled and will continue
to operate indefinitely at the speed
level you selected.
Aluminium filter fill warning
The light of
hours of operation. In this case, you must
clean your aluminium filter. After cleaning,
the lamp warning of
off automatically. When you touch the
key for more than 3 seconds, aluminium fil-
ter fill warning is reset and the lamp is
turned off.
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
the power is available, it continues
to warn with the light of
flashing.
EN / 14
key without set-
key while the timer is act-
key flashes after every 100
key does not turn
key
Publicidad
