Publicidad
Idiomas disponibles
Idiomas disponibles
DSP 212, DSP 224, DSP 412, DSP 424
A
NOTICE!
• Before start-up, check that the voltage specification on the type plate
is the same as that of the power supply.
• Ensure that other objects cannot cause a short circuit at the contacts
of the device.
• Never pull the plug out of the socket by the connection cable.
• Store the device in a dry and cool place.
2.3
Safety when installing the device
D
DANGER!
• Never mount the device anywhere where there is a risk of gas or dust
explosion.
!
CAUTION!
• Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
A
NOTICE!
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
• Set up the device in a dry location where it is protected against splash-
ing water.
2.4
Safety when connecting the device electronically
D
DANGER! Danger of electrocution
• If you are working on electrical systems, ensure that there is somebody
close at hand who can help you in emergencies.
!
WARNING!
• Never connect more than one consumer device to the inverter. If you
connect more than one device, a short circuit may occur.
• Make sure that the lead has a sufficient cross-section.
• Lay the cables so that they cannot be damaged by the doors or the
bonnet.
Crushed cables can lead to serious injury.
EN
General safety instructions
11
Publicidad
