Topcom RC-6401 Manual De Usuario página 5

8 GETTING STARTED
9 CHARGING BATTERIES
TOPCOM TWINTALKER RC-6401 DUO COMBI PACK
TOPCOM TWINTALKER RC-6401 DUO COMBI PACK
8.1 REMOVING/INSTALLING THE BELT CLIP
1.To remove the clip from the unit, push the belt clip (2) towards
the antenna, while pulling the clip tab (1).
2.When re-installing the belt clip, a click indicates the BeltClip is
locked into position.
8.2 BATTERY INSTALLATION
1.Remove the belt clip (§ 8.1).
2.Pull the battery door tab down (3) and slide the battery cover
away from the antenna. (4)
3.Install 3'AAA' rechargeable batteries following the polarity as
shown.
4.Re-install the Battery Cover and Belt Clip (§ 8.1).
When batteries are installed, the desktop charger provides drop-in
charging conveniency
1.Put the desktop charger on a flat surface.
2.Plug one end of the supplied adapter into the electric socket and the
other end into the connector on the backside of the desktop charger.
3.Put the radio in the charger as indicated.
4.The charging LED will turn on if it's properly inserted and charging.
It will take about 7 to 10 hours to fully charge the batteries
5