Topcom RC-6401 Manual De Usuario página 7

13 CHARGING RECHARGEABLE BATTERIES
The PMR can be used with 3 rechargeable NiMh AAA batteries.
Only use the AC/DC ADAPTER with "AAA" rechargeable batteries. Do not try to charge
this unit when regular "AAA" alkaline batteries are installed.
When using rechargeable batteries you can use the optional adapter to charge.
• Insert 3 "AAA" rechargeable batteries .
• Plug the small plug of the 7,5 V DC / 300 mA adapter into the SPK/MIC/CHG jack and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries properly. There is no
charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.
14 USING THE TWINTALKER RC-6401
14.1 TURNING THE UNIT ON/OFF
• To activate; press and hold
• To switch off; press and hold
14.2 ADJUSTING SPEAKER VOLUME
The Speaker Volume can be adjusted using
SC
LCD.
TX RX
14.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
SC
TX RX
14.4 TRANSMITTING A SIGNAL
• Press and hold
SC
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
• Release
TX RX
14.5 CHANGING CHANNELS
The PMR has 8 available channels.
To change channels:
• Press
• Press
SC
• Press
PTT
TX RX
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
TOPCOM TWINTALKER RC-6401 DUO COMBI PACK
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
In order for other people to receive your transmission, they must be set
on the same channel.
to TRANSMIT.
PTT
when you have finished transmitting.
PTT
once, the current channel number flashes on the LCD Screen.
or to change the channel.
to confirm the channel selection and return to NORMAL mode.
TOPCOM TWINTALKER RC-6401 DUO COMBI PACK
/ . The Speaker Volume level is displayed on the
7