Turning The Unit On/Off; Adjusting Speaker Volume; Changing Channels - Topcom TwinTalker 3700 Manual De Usuario

When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries
need to be replaced or recharged.
12 USING THE TWINTALKER 3700

12.1 TURNING THE UNIT ON/OFF

• To activate; press and hold
channel.
• To switch off; press and hold

12.2 ADJUSTING SPEAKER VOLUME

The Speaker Volume can be adjusted using
displayed on the LCD.
12.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When
you receive a signal on the current channel, the RX icon is displayed.
12.4 TRANSMITTING A SIGNAL
• Press and hold
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak
into the microphone.
• Release
PTT

12.5 CHANGING CHANNELS

The PMR has 8 available channels.
To change channels:
• Press
• Press
• Press
PTT
• To confirm and shift to the next option, press
NOTE: Any PMR set on the same channel can receive and listen to the conversation, also when the other
use a CTCSS code.
TOPCOM TWINTALKER 3700
Dispose of batteries at a designated battery disposal
unit and not in the household waste. Do not short-circuit
& dispose of in fire. Remove the batteries if this device
is not going to be used for a long period.
. The unit will "beep" and the LCD Screen will display the current
again. The unit will "beep" and the LCD Screen will turn blank.
In order for other people to receive your transmission, they
must be set on the same channel and CTCSS code.
to TRANSMIT.
PTT
when you have finished transmitting.
once, the current channel number flashes on the LCD Screen.
or to change the channel.
to confirm your selection and return to the NORMAL mode.
TOPCOM TWINTALKER 3700 DCP
and . The Speaker Volume level is
.
7