Whirlpool 103 ACO D Manual página 15

FOREWORD
The contents of this manual are generic and not all the functions described may be available on your
product.
The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or
copy errors. We reserve the right to make on our own products those changes to be considered necessary or useful,
without jeopardizing the essential characteristics.
Read the instructions for use very carefully paying particular attention to the rules concerning safety devices.
This appliance must only be used for what it has been designed for and built for.
DECLARATION OF CONFORMITY
The Manufacturer declares that the appliances conform to the EEC norms.
They must be installed in accordance with current standards, especially regarding aeration of the premises and the
exhaust gas evacuation system.
Note: The Manufacturer declines all and every responsibility for any direct damages caused by: an in-
correct use, wrong installation or bad maintenance.
EUROPEAN DIRECTIVE ROHS 2012/19/UE
This appliance is marked according to the European directive 2012/19/UE on Waste Electrical and Electronic Equip-
ment (WEEE).
By ensuring this product is disposed correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused by inappropriate waste
handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this ap-
pliance may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic equipment.
Disposal must be carried out in accordance with local environmental regulations for waste disposal.
1. WARNINGS
1.1. GENERAL WARNINGS
This manual has been prepared to enable a correct installation, regulation and maintenance of the appliance. It is
therefore of basic importance that the warnings contained in this booklet are carefully read as they supply essential
indications regarding the safety of the installation, use and maintenance.
This manual and the wiring diagram must be stored with care and made available to the operator for any future
consultation. The appliance must be installed, tested and serviced by qualified personnel in possession of the legal
qualifications. The constructor declines all responsibility with invalidity of the warranty in the event of electrical
and/or mechanical modifications.
Any adjustment whatsoever not expressly authorised and in disrespect of this manual invalidate the warranty.
Observe all existing local regulations at the time of installation. Check that the characteristics of the electric grid
correspond to the data given on the serial plate of the appliance. The packing materials (plastic bags, polystyrene,
nails, etc.) as potential hazards, must be kept out of the reach of children and properly recycled according to the
existing local regulations.
The appliance has been designed and constructed for the blast chilling and freezing of foodstuffs and should
therefore be destined to this sole purpose for which it has been expressly conceived. Any use besides this specific
purpose does not commit the constructor in any way. Shutdown the appliance in the event of breakdown or mal-
functions. For eventual repairs contact exclusively the authorised service centres and request the use of original
spare parts. If in doubt do not use the appliance and contact professionally qualified personnel. The disrespect of the
above conditions could risk the safety of the appliance.
1.2. TECHNICAL WARNINGS
The appliance must be used by qualified personnel. Keep off the children from the appliance above all if it is in
function. Every appliance has a serial plate on the right side.
1.3. USE WARNINGS
Remove from the room any stranger material as manual, plastic bags, polystyrene, nails, etc before start operating with
the equipment. Clean the inside and outside surfaces only with warm water and soap or a neutral detergent. Rinse
with plenty of water and dry thoroughly.
Don't use abrasive brushes or other damaging materials for the appliance's surfaces.
At the end of the working day, clean the inside (above all) and outside of the machine, to ensure smooth operation
of the appliance and prolong its useful life. Do not use high pressure water jets when cleaning the appliance.
15
EN