Whirlpool 103 ACO D Manual página 17

EN
C
A
B
3.3. UNPACKING AND DISPOSAL OF IT
Place the appliance on the ground in its chosen position.
Check that the serial number corresponds to the transport documents. Check for visible damages.
Keep the packing out of the reach of children, as it could be a danger hazard. Discharge the packing products to the
specialised collection or recycling points in respect of the existing regulations.
3.4. DISPOSAL OF UNIT
Before scrapping the appliance, keep it inoperative by removing the power cable, eliminating all parts of the
appliance that could constitute an hazard and invalidate locks, hinges and any other closing devices to avoid that
children playing could be trapped inside or injured.
IMPORTANT: COMPLY WITH LOCAL REGULATIONS IN FORCE CONCERNING THE FINAL DISPOSAL OF THIS TYPE OF
EQUIPMENT
4. START-UP
Before connecting the appliance check that the data on the serial plate correspond to
the actual electrical supply.
The serial plate giving the electrical data required in the installation is placed in the
right side.
The installation must be made according to the instructions given in this section, by
professionally qualified personnel.
THE ELECTRICAL SAFETY OF THIS APPLIANCE IS GUARANTEED ONLY WHEN IT IS
CONNECTED TO AN EFFICIENT EARTHING PLANT AS PRESCRIBED BY EXISTING
ELECTRICAL SAFETY REGULATIONS.
THIS BASIC SAFETY REQUIREMENT MUST BE VERIFIED AND, IF IN DOUBT, RE-
QUEST A CAREFUL CONTROL OF THE PLANT BY PROFESSIONALLY QUALIFIED PER-
SONNEL.
THE CONSTRUCTOR DECLINES ALL RESPONSIBILITY FOR DAMAGES CAUSED BY THE DISRESPECT OF AN
EFFICIENT EARTHING OF THE PLANT.
Check that the appliance is perfectly levelled.
Regulate the adjustable feet if necessary.
Check that the plastic protective coating is removed from all external surfaces.
Check that the interior is washed with warm water and a neutral soap.
Check that the appliance is positioned as far as possible from heat sources.
Check that the free air circulation around the motor compartment is not obstructed.
Control the voltage and frequency of the mains distribution, they must fall within the given values: 230 V ± 10%
; 50 Hz / 400 V ± 10% ; 50 Hz
17