Publicidad
Idiomas disponibles
Idiomas disponibles
8
www.aeg.com
space necessary for free circulation of
the cooling air, plus the space necessary
to allow door opening to the minimum
angle permitting removal of all internal
equipment
* including the width of the bottom hinges
(8 mm)
3.2 Location
To ensure appliance's best functionality,
you should not install the appliance in a
place with direct sunlight. Do not install
the appliance close to radiators or
cookers, ovens, or hobs, unless
otherwise specified in the installation
instructions.
Make sure that air can circulate freely
around the back of the cabinet.
This appliance should be installed in a
dry, well ventilated indoor position.
This appliance is intended to be used at
ambient temperature ranging from 10°C
to 38°C.
The correct operation of the
appliance can only be
guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Authorised Service Centre.
It must be possible to
disconnect the appliance
from the mains power
supply. The plug must
therefore be easily
accessible after installation.
3.3 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
3.4 Ventilation requirements
The airflow behind the appliance must be
sufficient.
min.
38 mm
200 cm
CAUTION!
Refer to the installation
instructions for the
installation.
3.5 Installing the SpinView
shelf
CAUTION!
Clean the accessory with a
soft moist cloth before first
use. Maximum load allowed
on the shelf is 15 kg.
1. Remove one of the glass shelves
from the fridge.
2. Remove the back trim from the glass
shelf
3. Slide in the SpinView
glass shelf's back edge.
2
min.
2
200 cm
®
®
clamps on the
Publicidad
