Fanimation The Celano v2 FP8062 Serie Manual Del Propietário página 12

NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and retain
the screw for later. Slightly loosen the remaining two
screws. Assemble the light plate assembly to the
motor assembly support bracket using the two key slots
in the light plate assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 1)
2. Remove one of the three screws in the light plate
assembly and retain the screw for later. Slightly
loosen the remaining two screws. Connect the 2 pin
connectors from the LED assembly to the 2 pin
connectors from motor assembly. (Figure 2 )
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
Installing Your Canopy Housing
WARNING
How to Assemble Your Light Kit
CAUTION
CAUTION
Light Plate Assembly
Light Plate
Assembly
LED Assembly
12
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1
Motor
Assembly
Figure 2