Fanimation The Celano v2 FP8062 Serie Manual Del Propietário página 9

How to Assemble Your Ceiling Fan
3. Route the black, white and blue wires through the
downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
6. Reinstall the hanger ball on the downrod as
follows. Route the black, white and blue wires
through the hanger ball. Position the pin through the
two holes in the downrod and align the hanger ball
so the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger
ball. A loose set screw could create fan wobble.
(Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the top of the downrod. Strip insulation off
1/2 inch from the end of each lead wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
(continued)
Set Screws and
Locking Nuts (2)
Ceiling Canopy
Canopy Screw
Cover
9
Black, White and
Blue wires
Figure 3
Downrod
Figure 4
Motor Coupling
Cover
Figure 5
Figure 6
Figure 7
Hairpin Clip
Clevis Pin