Publicidad
Step 12
1
D494
G
Groove
Insert the DRAWER SIDES (D494 and D495) at
å
an angle into the slot at each end of the UPPER
DRAWER FRONT (G).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D494
å
and D495). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the
å
groove of the DRAWER BACK (D78).
Repeat this step for the other drawer.
å
Page 16
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D495
D78
D494
D708
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D494
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D708) into the grooves
å
in the DRAWER SIDES (D494 and D495) and UPPER
DRAWER FRONT (G).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D495
419610
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
r f a
e d
c e
D708
D495
G
30S
(8 used in this step)
www.sauder.com/services
Publicidad
