Hoshizaki KMD-201AA Manual De Instrucciones página 4

6) Route the bin control lead through the hole in the base, then into
the bushing provided. See Fig. 4.
7) While pulling up the bin control lead, hook the bin control on the
right side interior wall. Then push the bin control up against the
bottom of the unit, and slide to the back until it snaps in place.
Make sure the slotted holes at the right side of the bin control are
securely placed on the collars at the bottom of the unit. See Fig. 5.
CAUTION
Make sure the bin control is securely in place. Otherwise, ice
may get between gaps and damage the bin control.
8) Pull up any slack in the bin control lead, then put the bushing
attached to the bin control lead back into the hole in the base.
9) Connect the bin control connector to the side of the control box.
10) Replace the water tank, cube guide, pump motor bracket, pump
motor and float switch in their correct positions until they snap in
place.
CAUTION
Be sure to let the discharge hose pass behind the copper tube
and connect it securely in position. See Fig. 2. Otherwise, the
discharge hose may be caught in the front insulation, leading to
improper results.
Bin Control Lead
Bushing
Fig. 4
Collars
Bin Control
Fig. 5
11) Secure the pump motor bracket with the two thumbscrews.
12) Reconnect the pump motor connector and float switch connector.
13) Replace the front insulation and front panel in their correct
positions.
5. ELECTRICAL CONNECTIONS
THIS APPLIANCE MUST BE EARTHED
This icemaker requires an earth that meets the national
and local electrical code requirements. To prevent possible
severe electrical shock to individuals or extensive damage to
equipment, install a proper earth wire to the icemaker. Remove
the plug from the mains socket before any maintenance, repairs
or cleaning is undertaken.
* This appliance requires a separate 220 - 240VAC, 10A supply. The
electrical supply must be protected by a suitable circuit breaker.
* The main control box fuse is rated at 5A, 250V and should only be
replaced by a qualified service engineer.
* Usually an electrical permit and services of a licensed electrician
are required.
* If the supply cord is damaged, it must be replaced by a replacement
cord available from Hoshizaki Parts/Service Centres.
For the U.K. and the Republic of Ireland only
* The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wire in the mains lead of this appliance may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured Green-and-Yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
symbol or coloured Green or Green-and-Yellow. The wire which
is coloured Blue must be connected to the terminal which is marked
with the letter N or coloured Black. The wire which is coloured
Brown must be connected to the terminal which is marked with the
letter L or coloured Red.
* Should the socket outlets in the installation site not be suitable for
the plug supplied with your product, the plug must be removed (cut
off if it is moulded on plug) and an appropriate plug fitted.
If the non-rewirable plug has been cut from the power supply cord,
it must be disposed of. There should be no attempt to reuse it.
Inserting such a plug into a socket elsewhere presents a serious
risk of electrical shock.
* The non-rewirable plug must never be used without a fuse cover
being fitted.
The correct replacement for the detachable fuse cover is identifiable
from the manufacturer's reference number stamped on the plug.
Supply of replacement fuse covers can be obtained from Hoshizaki
Parts/Service Centres.
Fuses should be rated at 10A and approved to BS 1362.
6. WATER SUPPLY AND DRAIN CONNECTIONS
Connect to potable water supply only.
3
ENGLISH
WARNING
WARNING