Taurus I3021T Instrucciones De Uso página 30

Downloaded by: pd-oliana on 30-01-2023 15:52 CET
INSTRUCTIONS
USE
Place the appropriate cookware on the cooking area that you want to use.
Make sure that the bottom of the cookware and surface are dry and clean.
Switch the device on by pressing the On/Off button and wait until "--" appears on the displays
Depending on the area where the cookware is placed, press the appropriate cooking area
selection control. Press the + or - buttons to select the desired power setting. On model I603F
slide the slider control from left to right to increase power up to the booster function. The power
control goes from 0 to 9, increasing the power in numerical order. If no power setting is selected,
the hob will switch off automatically. The power setting can be changed any time during cooking.
When you wish to stop cooking, select the active cooking area and lower the heat to power setting
0. The On/Off control can be used to stop cooking in all areas.
The H symbol remains visible as long as the particular area is too hot for contact. The symbol
disappears once the temperature in the cooking area drops to a safe level.
If the symbol
- The cookware has not been placed in the correct cooking area based on its size.
- The cookware used is not suitable for induction
- The cookware is too small.
In all of these cases, the cookware will not heat up. The signal automatically disappears after 2
minutes if no suitable cookware is placed on the hob.
Notes: When a control is pressed, the hob emits an audible signal.
If the power supply is interrupted during cooking, all selections made are cancelled.
USE OF THE TOUCH CONTROLS
The controls respond to touch, so there is no need to apply any pressure.
Use the flat of the finger, not the tip.
A beep is emitted each time a touch control is used.
Make sure that the controls are kept clean and dry and that there are no objects covering them
(e.g., a kitchen utensils or cloths). Even a thin coating of water can make the controls difficult to
operate.
COOKWARE
It is important to only use metal pots and pans specifically designed and/or approved for use on
vitro-ceramic induction hobs. Never allow melamine or plastic containers to come into contact with
the heated areas.
Do not use cookware with uneven edges or convex bases.
appears, this means that: