Mitsubishi Electric Fresh Master GUF-50RDH4 Instrucciones De Funcionamiento página 10

- The setting advances one minute every time the
pressed, and goes back one minute every time the
pressed.
When respective / buttons are pressed continuously,
the time display goes fast forward. It advances in the order of 1
minute digit - 10 minute digit - one hour digit.
- About 10 seconds after the button operation has been completed,
the "current time" and "time" displays disappear.
Caution:
- The Remote controller is equipped with a simplified clock
with a precision of about + or - one minute per month.
- The time must be readjusted (reset) every time the Fresh
Master is subjected to a power stop or a power failure.
3.2.7. Timer setting
- If the timer is set, the unit starts (stops) at the set time, and the
time mode is terminated.
- When you wish to confirm the starting and ending time, press the
[time selection] button while [timer] is displayed.
Function of timer
On-timer
Set the on-timer for the time the working day begins in your com-
pany.
When the set start time arrives, the Fresh Master starts operation.
Off-timer
Use the off-timer as a reminder to turn off the Fresh Master. When
the set end-work time arrives, the Fresh Master stops operation.
There are three methods for using the timer.
1. ON/OFF Timer When setting both starting and ending time
2. On-timer When only setting the starting time
(Ending time is set to "__ : __ ")
3. Off-timer When only setting the ending time
(Starting time is set to "__ : __ ")
Display example of timer setting
The example shows a timer set for operation start at 8:00 and end at 17:00.
[Timer] display
[Timer] button
[Time selection] button
button is
button is
ON OFF
ON OFF
[Starting/ending time] display
[Time setting] button
1 Press the [timer] button and erase the "timer" display
2 Press the [time selection] button and bring up the "starting
time" display
3 Press the ( ) button of the [time setting] and set the
starting time
When using it as an off-timer, set the starting time to "__ : __ ".
The "__ : __ " is displayed next to the time i.e. 23:50.
4 Press the [time selection] button and bring up the "ending
time" display
5 Press the ( ) button of the [time setting] and set the
ending time
When using it as an on-timer, set the ending time to "__ : __ ".
The "__ : __ " is displayed next to the time i.e. 23:50.
6 Press the [timer] button and bring up the "timer" display
Bringing up the [timer] display completes the setting.
Every time the ( ) button of the [timer setting] is pressed
once, it advances (or goes back) by 10 minutes.
If the button is pressed continuously, it advances (or goes back)
continuously.
First set the hour digit and then set the minute digit.
When the ON/OFF timer mode is set, you can run (on-timer) or stop
(off-timer) operation by pressing the [ON/OFF] button even when
there is remaining time.
Release
Press the [timer] button and erase the "timer" display.
9