Publicidad
Idiomas disponibles
Idiomas disponibles
Cord Rewind
Button
PRECAUTIONARY MEASUREMENT
If the opening that sucks in the air, the suction pipe or the telescopic wand stick on pipe is blocked, you
should switch off the vacuum cleaner at once. First clear the blocked substance before you attempt
to start the vacuum cleaner again.
1. Do not operate the vacuum cleaner too close to heaters and like radiators, cigarette
butts etc (see the fig.7).
Fig.7
2. Before you insert the plug into the wall contact, make sure your hand is dry
(see the fig.8).
3. Before you start using the vacuum cleaner, please remove large or sharp objects
from the floor in order to prevent that the paper filter is damaged (see the fig.9).
Fig.9
4. When you want to pull the plug from the wall contact, please do this at the
plug itself and not by means of the electrical cable (see the fig.10).
NOTE: If anything gets damaged, both the plug and the cable must be repaired by a qualified repairman
or electrician.
CLEANING AND MAINTENANCE
To change the dust bag
NOTE:
1) Always operate the cleaner with dust bag installed.
2) If you forget to attach the dust bag or attach it in the incorrect manner, the front cover may not close
completely.
The details as following (see the fig.11):
• After removing the extension tube assembly, open the
front cover by pushing the lock block upward.
the dust bag from the bag support.
• Replace the paper bag when it is full of dirt.
• Place a new paper bag into the unit.
• Close the cover by pushing down until it is locked.
2. To rewind the power cable, press the rewind button with one hand
and guide the cable with the other hand to ensure that it does not whip
causing damage.
- 12 -
Fig.8
Fig.10
Fig.11
Publicidad
