Publicidad
Idiomas disponibles
Idiomas disponibles
How to Operate Your Ceiling Fan (continued)
6. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
1)
After installing and wiring the unit, restore power to your
fan by ensuring that the breaker and wall switch that
controls the power supply is moved to the on position,
press and hold the "SET" button inside of the battery
compartment of the handheld remote control for 1-3
seconds.
2)
You must press the "SET" button within 30 seconds of
restoring power to the fan.
3)
When restoring power to your fan at the wall switch and
breaker, DO NOT press any button(s) on the
handheld remote control before pressing the "SET" button,
otherwise the fan will fail the learn procedure.
4)
If you press any button(s) on the handheld remote
control before pressing the "SET" button, please turn the
wall switch that controls the power to the fan to the o
position then on again, and start the process beginning
with Step 1 above.
7. Remote functions: (Figure 5)
• Indicator LED light: fan speed and light
dimmer indicator
•
button: Tap once turn off the fan. Press and
hold this button for 5 seconds to turn on or turn off
the buzzer.
• Fan Speed:
Turn on the fan and turn speed up.
Turn on the fan and turn speed down.
•
Light button: Turn ON\OFF the light.
Increase light output level.
Decrease light output level.
• Sleep Timer:
The fan and light will turn off after 1 hour.
The fan and light will turn off after 3 hours.
The fan and light will turn off after 6 hours.
•
Home Away: Tap this button, the light will
blink twice signaling this feature is on; the fan
will turn off and the light will randomly turn on
and off while you are away. Pressing any button
will cancel the feature.
8. "D" and "O" dip switch:
For this fan, switch should be in the "D" position, allowing
for dimming of the light. (Figure 6)
The receiver provides the following protective function:
Lock position: The DC motor has a built-in safety feature
against blade obstruction against obstruction during
operation. If something obstructs the fan blades the motor
will stop operating after 60 seconds of interruption. Please
remove obstacles and reset.
Dip Switch
When you press the "SET" button the fan will make
5)
two musical sound and light will blink twice, and it has
finished the control set up process.
The fan is now ready for normal use.
6)
•
Fresh Air: Fan speed will modulate to
simulate a natural breeze.
•
Safe Exit: Tap once, the light will blink once;
fan and light will turn off after 1 minute. Pressing
any button will cancel this feature.
•
Reverse button:
Summer- The fan runs counterclockwise.
Airflow will provide a downward cooling breeze.
Winter- The fan runs clockwise. Airflow will force
warm air downward without a noticeable breeze.
Dip Switch
15
SET
Figure 4
Figure 5
SET
Figure 6
Publicidad
