Trevi MAX 20 Manual De Usuario página 33

network operator. If the code is wrong, an error message will be prompted on the
screen. After selecting a call barring option, continue to select Activate or Deactivate.
The mobile phone will prompt you to input the call barring code and then contact the
network. A moment later, the network will make a response and send the operation
results to the mobile phone.
- Hide ID: You can select hide ID, display own ID and or display ID by network.
- Others: You can set blacklist, auto call record, auto redial, call time minute reminder,
vibration when connected and reply SMS after reject through this function.
Phone Settings
- Date & Time: Set the date format, the time format, and detail time of the location.
Note: If you remove the battery from the mobile phone or if the battery energy was
exhausted a long time ago, you may need to reset the date and time when re-inserting
the battery or powering on the mobile phone after recharging.
- Language settings: Select the display language and writing language for the mobile
phone.
- Shortcut settings: Select preferred function as shortcut on screen direction key as
needed.
- Dial voice: You can open or close voice repetition of the number while dialing the number
- Call voice: You can open or close voice repetition of the number of the incoming call.
- Set vibrate level: You can set the vibrate level among those set.
- Restore factory Settings: Use this function to restore factory settings. The preset
password is 1234.
Display
Users can access this item to set Wallpaper, Idle display, Contrast, Backlight and keypad
backlight etc.
Security
This function provides you with related settings about safety use:
- PIN: To activate PIN lock, you need to input the correct PIN code. If you set PIN lock to
On, you need to input the PIN each time you power on the mobile phone. In the case
you input a wrong PIN for three consecutive times; you need to input the PIN Unblocking
Key (PUK). The PUK is used to unlock and change the locked PIN. To obtain the PUK,
contact the network operator.
- Modify PIN: To change PIN code.
- Phone locked: The function enables you to lock/unlock the phone. Entering password
to switch on or off the phone. Password is required when the phone is locked. The initial
password is 0000.
- Modify the cellphone password: To change the cellphone password.
33