Pur Line NTW-08 Manual De Instrucciones página 8

· CAUTION: in order to avoid a hazard due to inadvertent resetting of the thermal cu-
tout, this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the utility.
INSTALLATION
Before the installation, please make sure to meet the below requirements:
- The control panel must be in the bottom position while installation.
- The distance between the bathtub and the apllance should be at least 6 0 cm
- The distance between the top of house and the appliance should be at least 1 5 cm.
- The distance between the ground and the appliance should be at least 80 cm.
WARNING: In order to avoid a hazard for very young children, its recommended install this appliance so that
the lowest heated rail is at least 60 cm above the floor.
PARTS LIST
EN
1. The control panel must be in the lower
position during installation.
2. The distance between the bathtub and the
appliance must be at least 60cm.
3. The distance between the top of the house
and the appliance must be at least 25 cm.
4. The distance between the floor and the
appliance must be at least 80cm.
6
1. Heating bars
2. Side supports
3. Temperature indicator
4. 1h heating time button
5. 0n/off button
6. Wall brackets
7. Fixing screws
8. Wall plugs
9. Wall screws