Imetec N7805 Instrucciones De Uso página 21

This chapter describes the most common problems that can arise using the appliance. If the problems
cannot be solved with the information below, please contact the Authorised Assistance Centre.
Problem
Scale on the wave
plate.
There are small marks
or little cracks on the
plate.
The plate (7) remains
cold or does not heat
up.
The plate temperature
LED (1) goes on and
off.
Only a little steam
or none at all is
dispensed.
The impurities that
come out
from the steam holes
stain the garments.
Water leaks from the
plate.
TROUBLESHOOTING
Possible cause
Scale has deposited after the
iron has been used.
The appearance is the result
of the special hard anodised
surface.
There is no power
supply.
Normal procedure.
The steam selector (10) is in
the steam closed position.
There is not enough water in
the reservoir (6).
Possible residues in the plate
(7).
Chemical additives, scented
liquids or descaling agents are
being used
Starch is being used.
Plate temperature (7) too
low due by pressing the
super-steam button (12) too
frequently.
The temperature adjustment
knob (3) is set to a temperature
that is too low.
Solution
Let the iron cool down, then clean the
plate with an abrasive sponge (of the type
for cleaning dishes).
This is a special product feature, that
makes the plate highly resistant to
scratches.
Check if the power supply cable plug (2)
is inserted correctly or try inserting it in
another socket.
Check whether the temperature
adjustment knob (3) is set to the minimum
temperature (Fig. D).
The switching ON and OFF of the LED
indicates the heating phase of the
iron. The LED goes off once the set
temperature is reached.
Move the steam selector (10) to the
desired position (Fig. C).
Fill the reservoir (6).
Perform self-cleaning (see the Calc-Clean
System paragraph).
These substances damage the product:
do not add additives to the water in the
reservoir.
Always spray the starch
on the reverse side of the fabric.
Allow slightly longer intervals
between the jets of steam.
Turn the temperature adjustment knob (3)
to a position between the 3 dots and the
maximum temperature (Fig D).
EN
18