Sage Barista Touch Impress Guia Del Usuario página 23

Troubleshooting
PROBLEM
Water does not
flow from the group
head
No hot water
No steam
The machine is
ON but ceases to
operate
Coffee runs out too
quickly
Coffee is too cold
No crema
POSSIBLE CAUSES
• Water tank is empty.
• Water tank is not fully inserted
and locked into position.
• Water tank is empty.
• Steam wand is blocked.
• The coffee grind is set too
coarse.
• Not enough ground coffee in
the filter.
• Cups not preheated.
• Milk not heated enough (when
making a milk based drink).
• Coffee beans are stale.
WHAT TO DO
Fill tank.
Push water tank in fully and lock latch
closed.
Fill water tank.
Use the pin on the end of the provided
cleaning tool. If steam wand remains
blocked, remove the tip using the
integrated spanner in the cleaning tool
and soak in hot water. Screw tip back
onto the steam wand using the integrated
spanner in the cleaning tool.
Turn machine off. Wait for 60 minutes
and turn machine back on. If problem
persists, call Sage Consumer Support.
Adjust the grind size to a lower setting.
Refer to 'Setting The Grind Size And
Dosing' under Functions.
Pre-heat cups.
Check selected milk temperature setting.
Use freshly roasted coffee beans with
a 'Roaster On' date and consume
between 5-20 days after that date.
EN
23