Switching The Push Assistance On/Off; Setting The Assistance Level - Bosch Purion Instrucciones De Servicio

English – 8
Changing the batteries
(10)
If the on-board computer shows LOW BAT on the dis-
play, remove the on-board computer from the handle-
bars by unscrewing the fastening screw (3) of the on-
board computer. Open the battery compartment
cover (10) using a suitable coin, remove the used
batteries and insert new CR2016 batteries. You can
obtain batteries recommended by Bosch from your
bicycle dealer.
When inserting the batteries, ensure that the polarity
is correct.
Close the battery compartment again and fasten the
on-board computer to your eBike's handlebars using
the fastening screw (3).

Switching the push assistance on/off

The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-
lected gear and can reach a maximum of 3.7 mph.
1 270 U20 XBP | (08.04.2020)
L K L K L K L K L K L K L K L K L K L K L K L K L K L K L K K K K K K K K K K K K K K K K K K K K K K
A L A L A L A L A L A L A L A L A L A L A L A L A A L A L A L A L A L A L A L A L A L A L A L A L A L L L L L
A A A A A A A A A A A A A A A A A A A A A A A A A A A A A A
W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W W
(3)
(4)
The lower the selected gear, the lower the speed of
the push assistance function (at full power).
The push assistance function must only be used
u
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance, briefly press the
WALK button on your on-board computer. After acti-
vation, press the + button within 3 s and keep it
pressed. The eBike drive is switched on.
Note: The push assistance cannot be activated at as-
sistance level OFF.
The push assistance is switched off as soon as one of
the following occurs:
– You release the + button;
– the wheels of the eBike are locked (e.g. by applying
the brakes or hitting an obstacle);
– the speed exceeds 3.7 mph.
The push assistance function is subject to local regu-
lations; the way it works may therefore differ from the
description above. It can also be deactivated.

Setting the assistance level

You can set the level at which the eBike drive assists
you while pedaling on the on-board computer. The as-
sistance level can be changed at any time, even while
cycling.
Note: In some models, the assistance level may be
preset and cannot be changed. There may also be
fewer assistance levels available than stated here.
The following assistance levels are available as a max-
imum:
– OFF: Motor assistance is switched off. The eBike
can just be moved by pedaling, as with a normal bi-
cycle. The push assistance cannot be activated at
this assistance level.
– ECO: Effective assistance with maximum effi-
ciency, for maximum range
– TOUR: Steady assistance, long range for touring
Bosch eBike Systems