Princess 242120 Manual De Instrucciones página 18

• Briefly press the start/stop button (2) to
start the deventilation. The water starts to
flow out of the coffee dispenser (5) after
approximately 25 seconds. The pump
switches off automatically.
• Set the dispenser selector (4) to position
'D'. The water is heated until the start/stop
button (2) changes from red to green after
approximately 80 seconds.
• Place one cup under the hot water
dispenser (7) and one cup under the milk
froth dispenser (8).
• Set the dispenser selector (4) to position 'B'.
• Briefly press the on/off button (1) and the
start/stop button (2) at the same time.
• If the cup under the hot water dispenser (7)
is full, set the dispenser selector (4) to
position 'C' while the pump is running.
The pump switches off automatically.
• Set the dispenser selector (4) to position
'A'. The water is heated until the start/stop
button (2) changes from red to green.
Designation of the indicators
Component Indication
On/off button (1) Yellow
Yellow flashing Descale the
Blue
Blue flashing
Start/stop Red
button (2)
Red flashing
Green
Green flashing Bleed the new
Switching on and off (fig. A)
• To switch on the appliance, press the on/off
button (1). The start/stop button (2) flashes
red. The start/stop button (2) becomes
green when the appliance is ready for use.
• To switch off the appliance at any time,
press the on/off button (1) again.
Designation
Descaling program.
appliance.
Active steam mode.
Descale the
appliance.
Steam mode is not
possible.
The appliance is
heating or rinsing.
Fill the water reservoir.
The appliance is
ready for use.
appliance.
18
Automatic switch-off function
The appliance switches off automatically if it is
has not been used for a period of 60 minutes.
Water level indicator (fig. A)
The fresh water supply is monitored
continuously by a float which moves up and
down in the water reservoir (13). The start/
stop button (2) flashes red when the level
comes below the required minimum filling
quantity. The process will resume when the
filled water reservoir (13) has been placed
back in the appliance.
Pre-brewing function
The pre-brewing function makes sure that the
appliance initially only supplies a small
quantity of water. The coffee-making process
continues after a short interval.
Setting the cup size (fig. B)
The cup size selector is used to set the
required quantity of water to be delivered from
the appliance.
• Set the cup size selector (3) to the required
position. Refer to the table below to set the
correct cup size.
Setting Cup size
A 1 cup of espresso
B 1 normal cup of coffee
C 1 large cup of coffee
D 2 normal cups of coffee
E 1 extra large cup of coffee
Selecting the dispenser (fig. C)
The dispenser selector is used to select the
required dispenser for the type of beverage to
be made.
Caution! Set the dispenser selector (4) to
position 'A' after each use.
• Set the dispenser selector (4) to the
required position. Refer to the table below
to select the correct dispenser.