Publicidad
If you have an indoor Omni ceiling antenna, the best place to install it is the center of your house. Install Omni ceiling
antenna as shown in the graph below.
Note: the required distance between the indoor and outdoor antennas is 10-15 m. Step 3. Install Signal Booster
Step 3. Install the Mobile Signal Booster
1. Select the location near a power supply on a wall.
2. Mount the booster with the screws included into the kit as shown on the graph below.
Single and Dual Band
3. Connect the outdoor antenna cable to the booster connector marked as "outdoor". Tighten the connection by hand or
with a wrench.
4. Connect the indoor antenna cables to the booster connector marked as "indoor". Tighten the connection by hand or
with a wrench.
5. Connect the AC power cord to the signal booster, then connect the plug to the electrical outlet to power on the
booster.
Note: the required booster mounting distance above the floor is 1-1,8 m.
If it's necessary to install multiple indoor antennas solution, please contact us, We will provide you with a professional
installation plan.
Step 4. Booster Commissioning
The booster has an intelligent startup system; booster commissioning is an automatic process able to guarantee an
optimal system performance.
As soon as you finish the booster system installation, plug it into a power supply to start the booster. It will start working
and checking the receiving signal strength and the isolation to ensure the best system performance. Automatic
adjustment will take about 3-5 seconds.
After the booster starts working, check the coverage. If the signal has improved throughout your home/office, the
booster commissioning is completed.
In case the coverage is not enough, please check the following issues.
1. The rated output power is reached, but the coverage is not enough or the signal in some areas has not improved：
Check whether the indoor antenna is installed correctly or not, try to change the antenna position to improve
coverage.
Check if it is necessary to adjust the direction of the indoor antenna.
Check whether it is necessary to add more indoor antennas since the obstructions （thick walls, reinforced fence,
natural barriers like hills, mountains, etc.）block the signal.
2. The rated output power is not reached.
Change the position or direction of the outdoor antenna to get a stronger receiving signal and higher output power
(Not necessarily to reach the rated value as long as the coverage is enough).
Triple and Quintuple Band
Hi103S/Hi105S
12
Publicidad
