Descargar Imprimir esta página

HiBoost Hi10-EGSM Manual De Usuario página 8

Publicidad

"ULdB"" DLdB"- gain indication.
The displayed value shows real-time uplink and downlink gain.
"Power dBm"- power indication.
The displayed value shows real-time power. When booster's output power is 4OdBm lower than rated output power, the
value will display "---".
"ISO"_ isolation alarm indication.
When the booster doesn't have enough isolation between the outdoor and indoor antennas, the "ISO" is flashing. Press
the "SET" key and the LCD screen will display " ISO" value showing the current affected band or bands.
"ALC"- strong receiving power alarm indication.
When the booster's receiving too strong signal from outside, output power gets overrated and "ALC" starts flashing.
Press the "SET" key and the screen will turn on and show the affected band or bands.
"OFF"- booster shut-down alarm indication.
When LCD screen is in "OFF" state and the booster shuts down, LCD screen will be flashing. When LCD screen is "ON"
and the booster shuts down, "OFF" is flashing.
Press the "SET" key and the screen will show the affected band or bands.
Control Button and Manual Gain Control (MGC)
There are 5 operation modes relative to the control keys:
Press the "SET" key for more than 3 seconds
Briefly press the "SET" key
Briefly press the "DEC-" key
Briefly press the "INC+" key
Simultaneously press the "DEC-" and "INC+" keys for more than 3 seconds Since the booster has a self-adaptive
smart automatic level control (ALC), and isolation gain processing (ISO), most of the time manual adjustments are not
required to achieve good coverage. However, in some cases when the ALC or ISO are working at a very high rate to
adjust the gain and the Alarm or ISO LED is flashing more than once a second, a manual adjustment might be
required. When LCD is in the fixed display mode, press the "SET" key for more than 3 seconds. It will go into the "Gain
Setting Mode" and make one of the gain values start to blink.
Press the "SET" key briefly, and the LCD will switch to the next gain value and it will start blinking. (Uplink or downlink
8

Publicidad

loading