Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
DANGER
When the electronic instant hot water appliance is full, water will flow from the instant hot
water tap spout. Allow water to flow for 3 minutes so that the water runs clear.
Turn the instant hot water handle off and check all connections for water tightness and leaks.
Any leaking joint must be tightened to ensure no water leakage and the above priming
undertaken again and checked for water tightness before connecting to the power socket.
Step 4 - Connect the plug to the power socket and turn on the power socket at the
switch.
Slide the switch to the ON position to power on the unit. Once the unit has powered on, the
Power Indicator LED light will light up red.
The unit will then start heating the water to 98°C. If the water is less than 98°C, the Heating
Indicator LED light will light up red. Once the tank has reached 98°C, the Heating Indicator
LED will light up yellow.
Power Indicator
Heating Indicator
OFF
ON
Publicidad
