Publicidad
Idiomas disponibles
Idiomas disponibles
Installation - Continued
Step 2 - Connect Tap
The electronic instant hot water appliance
inlet connection is a 3/8"BSP male
threaded connector. The outlet connector is
3/8"BSP male thread connected to a push
on connector.
Check the connections type and size
on the instant hot water tap for the inlet
connections.
Fitting a pressure reducing valve to the
cold mains inlet if the mains pressure is
above 5bar. The fittings have silicone/
rubber washers - Do not overtighten.
This could cause washers to split.
Installation Procedure
1. Install the hoses onto the tap.
Connection
to filter's
PVC pipe
Silicone tube
(pre-installed)
2. Insert the hoses through the tap hole
Note: Insert hot/cold hose first, then the
boiled in hose by inclining the nut. Insert
the silicon tube lastly.
Hot Water Outlet
On/Off Switch
Connection to
hot water feed
Connection to
cold water feed
Power Cable
1
Clear
Silicone Tube
Cold water Inlet
Power
Indicator
Heating
Indicator
2
Publicidad
