Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Requirements
WARNING
A 220/240-volt, 50 Hz, AC -only 13 amp fused, grounded electrical power supply is
required. It is recommended that a separate circuit serving only electronic instant hot water
appliance be provided or use an outlet that can be turned on/off by a switch.
This electronic instant hot water appliance is equipped with a power supply cord with a
power plug. To minimise possible shock hazard, the cord must be plugged into mating,
ground-type outlet, grounded in accordance with all national and local codes and
ordinances. If a socket outlet is not available, it is the responsibility and obligation of the
customer to have a properly grounded outlet installed by a qualified electrician.
WARNING
If local codes permit, the instant hot water tap feed line should be connected to the hot and
cold water supply line using isolation valves or another means for providing the hot and cold
water to the tap.
IMPORTANT: If local codes do not permit the use of isolation valves, special feed valves can
be obtained from your local plumbing supply distributor.
WARNING
Don't install the electronic instant hot water appliance outdoors or in location that may fall
below 0°C, otherwise the pipes and the tap will be frozen and there will be serious safety
trouble, possible bodily injury, accidents and damage caused.
It's forbidden to wash the electronic instant hot water appliance with water directly.
The installation environment should be ventilated, with protection from the direct sunshine.
When installing the electronic instant hot water appliance, provide approximately 10cm to
15cm (4-51/2") of air space on the sides of the unit for air circulation and approximately
2.5cm(1") from the mounting wall.
The environment humidity should be in the range of 10% to 60%. Be sure there is no dew.
WARNING
Connecting a standard tap may cause injury and will damage the electronic instant hot water
appliance and void the guarantee. Due to high water temperature, and for safety reasons, the
electronic instant hot water appliance is not under pressure.
Electrical Requirements
Water Supply Requirements
Environment Requirement
Instant Hot Water Tap Information
Publicidad
