Preparation For Installation
Unlike other household hot water
appliances, this electronic instant hot water
appliance is Non Pressurised for safety
reasons. For this electronic instant hot water
appliance, the Instant Hot Tap is placed
before the electronic instant hot water
appliance, creating an "open vent" system
and consequently no pressure is built up
inside the appliance.
WARNING
IMPORTANT: Install the Instant Hot
Water Tap in accordance with the
fitting Instructions provided with the
Hot Water Tap.
Preparation for the electronic instant hot
water appliance installation
IMPORTANT: Observe all local
governing codes and ordinances.
The electronic instant hot water appliance
must be mounted vertically and level.
Installation
WARNING
Step 1 - Position the Instant Hot Water Appliance
Ensure the electronic instant hot water appliance is NOT connected to the Electric Power
during installation.
Place the electronic instant hot water appliance in position and check to ensure that
the instant hot water tap connection pipes and the power cord will reach without being
stretched.
The electronic instant hot water appliance must be positioned so the tubes from and to the
instant hot water tap do not twist or kink.
Before you begin, select a suitable location
ideally directly under the instant hot water
tap or close to it to ensure the connection
pipes will connect from the instant hot
water tap to the electronic instant hot water
appliance.
The electronic instant hot water appliance is
not under pressure, consequently, there is a
slight delay in water flow after the Hot Water
Handle has been turned on. This is normal
and indicates that the electronic instant hot
water appliance is functioning properly.
It is recommended that you have access to
a separate power circuit serving only your
electronic instant hot water appliance. See
previous pages for more information on
"ELECTRICAL REQUIREMENTS".
Ensure that the electronic instant hot water
appliance is placed so that you will be able
to view and reach the power switch on the
front face for adjustments.