Urmet 1760 Manual De Uso página 13

1 VOICE COMMANDS
The video door phone allows the activation of some of the video door phone functions through voice
commands. By saying certain phrases it is possible, for example, to answer a call or open the pedestrian
door without pressing the keys on the display.
To use voice commands, enable the function in the video door phone configuration menu (refer to chapter
"Enabling and configuring voice commands").
ATTENTION! Below are only the default phrases for using voice commands. If you have made
"Voice command parameters configuration".
customizations to the phrases, refer to paragraph
To enable voice commands, first say the command "Hey Urmet" (voice commands can also be enabled
by moving your hand in front of the IR sensor on the front of the video door phone).
Hey Urmet
BEEP
The video door phone emits a "BEEP" as confirmation signal and the display shows the following pop up:
After the beep you can say the voice command.
ATTENTION! In voice status (in conversation) it is not possible to enable voice commands by saying
"Hey Urmet". To enable voice commands, place your hand in front of the video door phone IR detector
and then say the desired voice command.
Below are the instructions for using the voice commands to activate the functions.
13
DS1760-037