Descargar Imprimir esta página

Porter Cable CPLDC2540S Manual De Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
Drain water from air tank by opening drain valve (counter-clockwise) on
bottom of tank. NOTE: Tilt tank forward to drain tank completely.
rupture.
6.
After the water has been drained, close the drain valve (clockwise). The air
compressor can now be stored.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, then reinstalled.
Oil
Checking
1.
Set the On/Auto/Off lever to "OFF".
2.
Remove dipstick (A) and check oil on dipstick for visual signs of
contaminants (water, dirt, etc).
debris. If air vent is blocked pressure
can build in crankcase causing damage
to air compressor and possible personal
injury.
3.
Wipe oil from dipstick.
4.
Replace dipstick and allow oil to
collect on dipstick.
5.
Remove dipstick and check oil level
on dipstick, + mark indicates full and
the - mark indicates add oil. If oil level
is below - mark, slowly add oil until it
reaches the + (full) mark on the dipstick.
NOTE: Use a air compressor oil such as SAE-30 (API CG/CD heavy duty motor
oil. Under extreme winter conditions use SAE-10 weight oil.
6.
Replace dipstick (A).
Changing
1.
Set the On/Auto/Off lever to "OFF".
2.
Remove the dipstick (A).
3.
Remove the oil drain plug (B) and drain oil into a suitable container.
4.
Replace the oil drain plug (B).
A02250
Water will condense in the air tank. If not drained, water will
corrode and weaken the air tank causing a risk of air tank
Drain tank to release air pressure before removing the
dipstick or oil drain plug.
Compressor head and cylinder sleeve are very hot. Do not
touch.
Make sure air vent (C)
in dipstick is free from
(+)Full
(-)Add
16- ENG
C
A
B

Publicidad

loading

Este manual también es adecuado para:

Cpldc2540s-ca