Publicidad
Idiomas disponibles
Idiomas disponibles
How to Install Your Canopy Housing
NOTE: This step is applicable after the neccessary
wiring is completed.
1.
Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care
not to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later and slightly loosen the
remaining two screws. (Figure 1)
2.
Assemble the light plate assembly to the support
bracket using the two key slots in the light plate
assembly. Replace the previously removed screw and
securely tighten all three screws. (Figure 2)
How to Asasemble Your Light Kit
Motor Assembly
Light Plate
Assembly
14
Ceiling Canopy
Shoulder Screw
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1
Figure 2
Publicidad
