Publicidad
Idiomas disponibles
Idiomas disponibles
How to Asasemble Your Light Kit (Continued)
3.
Remove one of the three screws in light plate
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 3)
4.
Securely attach the 9-pin light kit connector to
the wiring harness socket within the motor assembly.
(Figure 4)
WARNING
The color label on these two connectors must
correspond to each other.
5.
Assemble the light kit to the light plate assembly
using the two key slots in light kit assembly. Replace
the previously removed screw and securely tighten all
three screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6.
Secure the light shade to light kit by twisting in a
clockwise direction. Do not over-tighten. (Figure 6)
Light Plate
Assembly
Motor Assembly
Light Kit
Light Plate
Assembly
Light Kit
15
Figure 3
Figure 4
Light Kit
Figure 5
Light Shade
Figure 6
Publicidad
