Holmatro IPU-S Serie Manual página 35

• Install the hydraulic oil drain plug and tighten it firmly.
• Check for severe contamination of the oil. Release the pump flange and clean the tank and oil filters
• Fill the tank through the filler opening with hydraulic oil.
• Check the level of the hydraulic oil.
• Vent the pump after replacing the oil:
- Leave the filler cap open during this operation.
- Connect a hydraulic tool.
- Start the pump.
- Let the oil flow through the hydraulic tool for two minutes.
• Install the hydraulic oil filler cap and tighten it firmly.
8.5 Yearly dealer maintenance
We recommend having the equipment inspected, checked, set and tested once a year by a Holmatro
Certified Technician who has the appropriate knowledge and the necessary tools (see also section 1.7).
The Holmatro dealer can organize the yearly maintenance for you on a contract basis.
8.6 Long term storage
• Clean the pump and re-tighten any screws that may have come loose due to vibration.
• Ensure that the equipment is completely depressurized.
• Store the equipment in a dry, well-ventilated area. Use additional preservatives on the external steel
parts.
9 Decommissioning/Recycling
At the end of its service life the equipment can be scrapped and recycled.
• Make sure that the equipment is put out of order to avoid any use.
• Check that the equipment does not contain any pressurized components.
• Recycle the various materials used in the equipment such as steel, aluminium, NBR (Nitrile
Butadiene Rubber) and plastic.
• Collect all dangerous substances separately and dispose of them in an environmentally responsible
way.
• Consult the Holmatro dealer about recycling.
IPU-S 916.000.972_002
EN
35