Pride Mobility BAJA Bandit Manual De Usuario página 26

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC CODES
The diagnostic codes for your vehicle are designed to help you perform basic troubleshooting quickly and easily. A
diagnostic code will sound and/or fl ash in the event one of the conditions listed below develops. Depending on the
model you own, your vehicle will communicate by one of the coding methods as follows:
1. A diagnostic code will begin, depending on model, with a series of fast beeps and/or fl ashes directly followed
by slower beeps and/or fl ashes which indicates the actual code. The code is only beeped and/or blinked once.
To repeat the diagnostic code, remove the key, then reinsert it and turn it to the "on" position, OR
2. A diagnostic code will identify the condition, pause, then repeat the code. The diagnostic code will continue
to alert you in this manner until the vehicle is turned off .
NOTE: Your vehicle will not run unless the diagnostic code condition is resolved and the vehicle has been
turned off , then turned back on.
NOTE: Ensure that the battery disconnect switch is in the "on" position (-) prior to charging your vehicle's battery.
The battery will NOT charge if the battery disconnect switch is in the "off " position (O). See fi gures 4 and 9.
DIAGNOSTIC CODE
■
(1)
■■
(2)
■■■
(3)
■■■■
(4)
■■■■■
(5)
■■■■■■
(6)
■■■■■■■
(7)
■■■■■■■■
(8)
■■■■■■■■■
(9)
What if my vehicle does not move when I press the throttle control lever?
 When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle assembly is cut.
 Pull back on the manual freewheel lever, turn the vehicle off , and then back on to return to normal operation.
26
CONDITION
Battery voltage is too low to operate the
vehicle.
Battery charge is too low.
The vehicle's battery voltage is too high to
operate the vehicle, or the charger is still
connected to the off -board charger port.
Current limit time out.
The manual freewheel lever is in the (forward)
freewheel position.
Throttle control lever not at center position at
start up.
Speed pot error.
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries as soon as possible.
Charge batteries.
Unplug charger and/or turn key off , then back on
again. If traveling down a slope, reduce vehicle
speed to the minimum setting.
Turn the vehicle off for a few minutes, then turn
your vehicle back on.
Remove the key from the key switch, then
push the manual freewheel lever to the drive
(rearward) position and restart your vehicle.
Verify that the batteries are fully charged. If
the batteries are fully charged, then return the
throttle control lever to center position, turn
vehicle off then back on.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
BAJA
®
Mobility BA140