melitta AromaFresh Therm Pro Manual Del Usuario página 20

Using the timer
6. Set the number of cups to
be brewed.
7. Start preparation with the "Start/Stop"
button.
6 Using the timer
The timer allows the appliance to automati-
cally start the preparation at a set time. You
need to set the time in order to use the timer,
see section 1 For your safety on page 15.
6.1 Preparing coffee with the
timer
1. Prepare the appliance as described in the
section 5.1 or 5.2 without pressing the
"Start/Stop" button.
2. Activate the timer with the "Timer" button.
3.
Select a start time with the left
function button.
4. Start the timer with the "OK" button.
» The start time is displayed on the screen
and the LED lights up white.
» Preparation starts at the selected time.
You can deactivate the timer before the end
of the start time by pressing the "Timer"
button again.
6.2 Setting the starting time
You can set two start times that you can then
select by pressing the buttons.
1. Press the "Timer" button.
2. Select the start time that you want
to change with the left function
button.
3. Press the right function button to
activate the setting.
4. Set the required time with the
function buttons. Confirm each
selection with the "OK" button.
5. Press the right function button to
save the setting and activate the
timer.
Use the left function button to save
the time. The timer is not activated,
however.
20
7 Changing settings
This menu contains functions for configuring
the appliance and for maintenance.
Press the right function button to call
up the menu. Navigate within the menu
using the two function buttons. Confirm your
entries with "OK". Press the "Start/Stop"
button to exit a function without saving the
setting. The current assignment of the function
buttons is shown on the screen.
The settings are retained even when you
disconnect the appliance from the electricity
mains.
Display Description
Descale: Starts the descaling program,
see section 9 on page 22.
Clean mill: Opens or closes the flap
for the ground coffee chute, see sec-
tion 8.4 on page 22.
The QR code calls up useful informa-
tion.
Time: Sets the time. Press the function
button to activate fast forward.
Mill: Sets the quantity of coffee beans
to be ground. This allows the brewing
strength to be changed.
1 bean = 90 % of the factory setting
2 beans = 100 % of the factory setting
3 beans = 110 % of the factory setting
Display: Sets the brightness of the
inactive screen.
Press the "Start/Stop" button for
3 seconds to darken the screen
manually.
Volume: Sets the volume of the signal
tones. The setting 0% deactivates the
tones. Error signals are always active.
Language: Sets the language.
Service/information: Shows the appliance
counter and the software version.
The Factory setting function resets all
settings to the original values. The
appliance counters are not reset.
Exit: Exit the menu.