Maintenance; Changing The Battery; Storage; Cleaning - Chauvin Arnoux F 09 Manual De Instrucciones

For maintenance, use only specified spare parts. The
manufacturer will not be held responsible for any accident
occuring following a repair done other than by its After
Sales Service or approved repairers.

7.1 Changing the battery

The clamp must be disconnected from any external electrical
source and must not be in contact with the cable.
Set the switch to OFF
Slide a screwdriver into the slot at the top of the battery
cover (rear of the clamp) and push the battery cover
upwards.
Replace the used battery by a 9 V battery, type LF22;
observe the polarities.
Install the battery in its housing, then install the battery
cover.

7.2 Storage

If the clamp is not used for a period of more than 60 days,
remove the battery and store it separately.

7.3 Cleaning

The clamp must be disconnected from any external
electrical source and must not be holding the cable.
Clean the unit and jaws with a cloth slightly moistened with
soapy water. Clean off with a damp cloth. Then dry quickly
with a cloth or pulsed air.
Do not splash water onto the clamp.
Keep the gap between the jaws in a state of perfect
cleanliness.

7.4 Metrological verification

It is essential that all measuring instruments are regularly
calibrated.
For checking and calibration of your instrument, please contact
our accredited laboratories (list on request) or the Chauvin
Arnoux subsidiary or Agent in your country.

Maintenance

Repairs under or out of guarantee: please return the product
to your distributor.
7. MAINTENANCE
46