Assembly; Operating Manual; Operating Element; Lifting The Vehicle - ATT Nussbaum JUMBO LIFT 3200 NT Instrucciones De Servicio

4.7

Assembly

i Follow the instructions enclosed in the anchor packaging.
5

Operating manual

When handling the system, it must ab-
solutely comply with safety regulati-
ons. Carefully read the safety regula-
tions in Section 3 before first operation!
5.1

Operating element

2
5
6
1 Main switch
o
2 „Lift" button
u
3 „Lower" button
4 Model plate
5 Access to the balance screws with locking nuts
6 Access to the emergency discharge screws with locking Nut
20110009 OPI Version 1.0
1
4
3
003
JUMBO LIFT 3200 NT - HYMAX XX 3200 PH
5.2

Lifting the vehicle

• Drive the vehicle over the drive rails lengthwise
and cross-wise in the centre.
• When driving onto the lift, position the ramps so
that the rollers (7) of the ramps (9) are on the
ground.
9
7
7 Rollers
8 Supports
9 Ramps
Otherwise the supports (8) and ramps (9) can be
damaged.
• Secure the vehicle against rolling. Apply the
handbrake, put into gear.
• Position polymer overlays below the receiving
points approved by the vehicle manufacturer.
If required, use the ramps for safe acceptance
i
of the vehicle. If the wheel base is too short,
fold the ramps underneath.
To receive the vehicle, the polymer
overlays cannot be placed on edge
otherwise there is a danger of the car
falling.
• Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
• Switch on controls. Turn the main switch (1) to
position „1" (see figure 003).
011
8
004
51