ATT Nussbaum JUMBO LIFT 3200 NT Instrucciones De Servicio página 6

ENGLISH
Contents
1 Introduction _____________________________ 46
2 General information _____________________ 47
2.1 Set up and test the system. ___________________ 47
2.2 Hazard information __________________________ 47
3 Safety regulations _______________________ 47
3.1 Safety inspection ____________________________ 48
4 Assembly and commissioning ____________ 48
4.1 Set up guidelines ____________________________ 48
4.2 Setting up the lift _____________________________ 48
4.3 Fill and vent the hydraulic systems ____________ 49
4.4 Commissioning ______________________________ 50
4.5 Changing the assembly location _____________ 50
4.6 Selecting the anchors ________________________ 50
4.7 Assembly ____________________________________ 51
5 Operating manual _______________________ 51
5.1 Operating element __________________________ 51
5.2 Lifting the vehicle ____________________________ 51
5.3 Lowering the vehicle _________________________ 52
5.4 Balance the drive rails ________________________ 52
6 Maintenance and care of the system _____ 52
6.1 System maintenance plan ___________________ 52
6.1.1 As required or visible damage ________________ 52
6.1.2 Maintenance 1 x per year ____________________ 52
6.1.3 Maintenance every 2 years __________________ 53
6.1.4 Maintenance every 6 years __________________ 54
6.2 Cleaning and care of the system _____________ 54
7 Behavior in cases of error ________________ 55
7.1 Moving onto an obstacle ____________________ 56
7.2 Emergency discharge during blackout ________ 56
8 Technical information ____________________ 57
8.1 Technical data ______________________________ 57
8.2 Safety devices _______________________________ 57
9 System master sheet _____________________ 58
9.1 Manufacturer ________________________________ 58
9.2 Purpose _____________________________________ 58
9.3 Changes to the design / construction _________ 58
9.4 Changing the assembly location _____________ 58
10 Data sheet ______________________________ 59
11 Foundation plans ________________________ 60
11.1 Sub-floor ____________________________________ 60
11.2 Above ground _______________________________ 61
12 hydraulic plan __________________________ 62
13 Replacement parts list ___________________ 63
6
Page
14 Set up protocol __________________________ 75
14.1 Transfer protocol _____________________________ 76
15 Safety inspection ________________________ 77
15.1 Single safety inspection before commissioning 77
15.2 Regular safety inspection and maintenance __ 78
15.3 Exceptional safety inspection ________________ 79
16 Notes ___________________________________ 80
17 Electrical circuit diagram _______________ 191
18 Declaration of conformity _______________ 200
18.1 JUMBO LIFT 3200 NT _________________________ 200
18.2 HYMAX XX 3200 PH __________________________ 201
JUMBO LIFT 3200 NT - HYMAX XX 3200 PH Version 1.0 20110009 OPI